Totality Wood Treatment
Totality Wood Treatment is the perfect solution for treating existing infestations of drywood and subterranean termites, carpenter ants, powder-post beetles and more!
Totality Wood Treatment works by creating a barrier to the structure by either pre-treating the wood or treating lumber after it has been installed by brushing, foaming, or spraying application. Wood must be completely covered to insure optimal pest control.
Totality Wood Treatment Features:
* Low use rate formula
* Only 1 coat required
* Long-lasting formula
* Can last in treated wood for over 6 years!
Totality Wood Treatment Uses/Applications:
Totality Wood Treatment forms an effective, treated barrier to the structure by either pre-treating structural wood or by treating lumber once installed via spraying, brushing, and foaming applications. Complete coverage of wood is essential for optimal wood-destroying insect control. The application of Totality Wood Treatment to both timber and timber-based products as specified in the application instructions will protect treated products from damage for up to two years from drywood and subterranean termite (including Formosan termites), carpenter ants, ambrosia beetles, and others.
Apply only to bare wood, plywood, particle board or other cellulose building materials in the absence of paint, stains or sealers. Such materials will prevent Totality Wood Treatment from properly adhering to cellulose surfaces. In areas where soil pretreatment is required by law, Totality Wood Treatment may be applied as a supplemental treatment to protect wood from subterranean termites that may penetrate chemical gaps or where soil is disrupted by construction practices.
Dilute as follows: Fill spray tank ¼-½ full with water. Add appropriate amount of Totality Wood Treatment as indicated in finished tank volume below. Shake and agitate small volume sprayers once filled. For larger spray units start pump to begin by-pass agitation and place end of treating tool in tank to allow circulation through hose. Add remaining amount of water. Let Pump run and allow recirculation through the hose for 2-3 minutes. Totality Wood Treatment may also be mixed into full tanks of water, but requires agitation to ensure uniformity of the emulsion.
Unless prohibited by a product's label, users can tank mix pesticides currently labeled for similar use patterns. It is always recommended that a small jar compatibility test using proper proportions of chemicals be run to check for chemical compatibility before tank mixing.
Totality Wood Treatment Target Pests:
Will Control Existing Infestations Of: Drywood and subterranean termites (including Formosan termites), carpenter ants, carpenter bees, ambrosia beetles, powder-post beetles, false powder-post beetles, deathwatch beetles, old-house borers and others in wood-in-place.
Totality Wood Treatment Active Ingredients:
Totality Wood Treatment EPA Reg. No. 279-3281
Totality Wood Treatment Size: 1 quart
Totality Wood Treatment Class: Pyrethroid
Totality Wood Treatment Category: Concentrate, Insectcide, Wood-boring insects
Totality Wood Treatment Manufacturer: FMC Corporation